I am really interested in seeing if mud or clay can light up the LED because it can help us generate electricity without damaging the enviroment.It can help us decrease the amount of the globe warming.This project can reduce the environment dirty air,and it is really cheap. This project main source comes from the ground that isn’t even worth money.I can go in my backyard and get the main source which Mud.My testable question is how can clay mud and my backyard mud be converted into electricity?My hypothesis is If I change the different type of mud then it would provide more electricity and will light up the LED. I will need to wash my hand first and sanitize my work area to be safe.Then I will need to find two different type of mud.I choose dirt from my backyard and clay.I will need to Place a plastic strainer or colander over a large mixing bowls.Then I will have to measure the soil to be 2 cups(470 milliliters mL).Then I will Gently shake the strainer over the bowl so that the soil is strained and any small, hard particles are removed from the soil.Add purified water and mix it in until my topsoil mud feels like cookie dough.Take the soil mud of my first soil type that I prepared fill the first vessel up to the line next to the 1 cm on the plastic vessel.I will have to put an anode on top of the mud in the vessel.The green wire from the anode should be sticking up. I will have to use more soil mud to fill the vessel up to the line next to the 5 mark (marking 5 cm).Run the green wire along the side of the vessel.I should remember that the orange wire from the cathode should be sticking out of the top side Take the white plastic lid and pass the wires through the small holes in the lid. Then carefully I have to snap the lid onto the plastic vessel.I will have to attach the hacker into the lid’s rectangular indentation. I will have to locate the positive and negative ports (holes) on the hacker board. Plug the cathode wire or the orange into the positive port and the anode wire or the green into the negative port. I should remember to locate ports one and two on the hacker board. Then I will have to plug the blue capacitor into these ports. Plug the red LED below the capacitor into ports five and six .The LED’s longer prong should go into port 5 and the shorter prong into port 6.The Specific amount in Metric System would 470 milliliters mL of mud.The Independent Variable would be the Type of Mud.The Dependent Variable would be if it creates electricity. Once I am done collecting all of my data from the mud and clay watt,I will have to create a graph that represent the powers and the days.I will have to check everyday to collect the power and the resistance of the experiment.The graph will show me how much power can be created to be converted to electricity.The graph will demonstrated by what can cause the mud to be converted into electrical so the LED can light.I will have to record the the time of the blinks of the anodes and how fast these occur on the graph.This method will help me find the right answer to my testable question.